Cyclone 360 Mark 3 Supply |
  |
 Oct 17 2009, 12:15 PM
Post
#1
|
|
|
|
Looking at updating power supply and keep being drawn to this any opinions folks ?
|
 |
 
|
|
Oct 17 2009, 12:34 PM
Post
#2
|
|
|
|
They can be a bit hit and miss with regards to the readings.
If your lucky you can get one that works. I´ve got one as back up and I´ve got an ems 300, the difference between the readings is I think about 0,5 so in theory you could use it to tune your machines. -------------------- |
|
|
|
|
Oct 18 2009, 09:41 AM
Post
#3
|
|
|
|
I've had 2 of them and never really had problems with either of them,other than one of them very occasionally would not show the numbers for a few seconds it would just show 0.00 for all readings,then after about 15-20 seconds they would pick back up and show again,but like i said that only happened every once in a while.
|
|
|
|
|
Oct 18 2009, 10:55 AM
Post
#4
|
|
|
|
I have one i've used for a while,works well,reasonable price
-------------------- Strick9
|
|
|
|
|
Oct 18 2009, 12:26 PM
Post
#5
|
|
|
|
Thanx for replies ..drawn to em bacuse of the ability to tune the machine in with them..........
|
|
|
|
|
Oct 19 2009, 05:06 AM
Post
#6
|
|
|
|
The numbers really wont help to much in tuning,since all machines run a little different from each other,i have tried tuning a few machines to the reccomended numbers and they did'nt run very well,they liked a different set of readings better haha.The numbers do come in handy to get a general starting point,and once you get the machine where you want write down the numbers to help re-tune it later.
|
|
|
|
|
Oct 31 2009, 06:41 AM
Post
#7
|
|
|
|
I ordered one 2 months ago but it arrived with a broken on/off switch so I'm still waiting for a replacement. But it looks
and feels a bit cheap (can't say how it's running though since... it's broken) I have in the shop ems-250 and cx-2 and can whole-heartedly recommend both. Ems-250 doesn't work with rotaries though in case that is important. (which is the reason why I had to order the cx-2) |
|
|
|
|
| Lo-Fi Version | Time is now: 17th March 2010 - 02:32 PM |
Skin designed by IPB Forum Skins